In these shots, the image automatically stretches to fill the bounding box. Note: The Fill feature is not active in Clock, Text, Solid, QR Code, or Web Page shots. Will respect the aspect ratio, so media may end up being obscured on the sides if your bounding box width is less than the media width (or it will have pillar bars on either side if the bounding box is larger)įills your bounding box, does not respect the aspect ratio of media, so may end up distorting your media. Will respect the aspect ratio, so media may end up being obscured top to bottom if your bounding box height is less than the media height (or will have letterboxing if the bounding box is larger)įills the bounding box to its height. Will respect the aspect ratio and will not crop your media.įills the bounding box to its width. An example of this is if your media is 4:3 but the canvas is 16:9, it will reset it to the original size, without fitting it using one of the “Fill” options which we will talk about here in a second.įills the bounding box until one side hits the edge. Clicking this will bring your source back to the original size it was imported into your Wirecast project. The reset position is the second of the two buttons under the scale wheel.
If you’re using the other features and lost your way, a quick “Scale to fit,” allows you to get back to an undisturbed image. One is called “Scale to Fit.” This allows you to take a source that doesn’t fit the canvas size, and scale it proportionately to fit the height and width of the canvas, without distorting the source.
There are two buttons below the scale wheel. A lot of users tend to use this to find a great size, then write the numbers down to get to that size in future projects. When you move the scale wheel, your size will increase or decrease for the source. This wheel will allow you to get a perfect size without knowing what the numbers should be. The scale wheel works hand in hand with the size. This allows for a “fine-tuned” adjustment. You can input a value for the sizing and the source will change to the desired number. The size works similarly to the position. You can also input your numbers if you know exactly where the asset needs positioned.
WIRECAST 7 USER GUIDE MANUAL
The numbers will change based on the manual movement of the source.
The position area allows for direct input of numbers on the position of your media or source. Let’s dive in and take a look at the shot layer’s properties. In Wirecast, the shot layers properties are a menu system that allows for manipulation of the sources added to a project.
0 kommentar(er)
